вторник, 12 июля 2011 г.

Check vysokovolt GOVERNMENTAL Wire

Check vysokovolt ¬ GOVERNMENTAL Wire
1. Disconnect the high-water of about spark plugs, keeping them only for rubber tip, as shown in the figure. Irregularity
Pravilmo Wrong


2. (In 4A-R 7A-REi4L-OE) Disconnect the high voltage wires from the distributor cap or lid of the combined ignition site. To do this, pull the spring with a screwdriver ¬ nuyu latch and remove the holding ¬ Tel together with high-conductivity ¬ house from the distributor cap, as shown in the figure.
3. Using an ohmmeter,check resistance ¬ tance of each high-voltage wire.
Note: 4A-R 7A-FE and 4A-OE wire resistance checked with the distributor cap or integrated electronic ignition unit.
Maximum resistance to ... 25 ohms each wire if resistance exceeds UCA ¬ zannoe value, check the tip ¬ nicks wires or replace the wire.
The type and brand of spark plugs Nominal ny gap, mm
4A-F (a model for Europe)
Type N0: 0L6AV-11 Type YOK: VSPE527U
SIatryup: RS111_SS4 0.8 0.8
4A-F (a model for countries in total exports), 5A-FE, 4A-FE, 5A-4A-RNE and RNU (models for Japan)
Type N0: 01 6F-11 Type YOK: VSRR5EU SNatryup: RS12US5 0.8
4A-OE (AE92 (to 87), and AT160)
Uq type: 020V-111 Type 1 YOK: VSRR6EU1 a SNatryup: RS9US4 1.1
4A-OE (AE92 (from '87)
Type N0: K20R-11 Type YOK: VKV6EUA 0.8
4A-FE (AE92, AE95, AT171 and AT180)
Type N0: 01 6F-11 Type N0 ^: VSRR5EU SNatryup: RS12US5 0.6
Caution: Make sure the holding ¬ Tel properly installed in the new resistor ¬ spacers and cover the distribution ¬ amplifier, as shown in the figure.
4. (In 4A-R 7A-FE and 4A-DE) Connect the high-pro-water to cover the distributor or the combined ignition site, as shown in the figure.
5. Connect the high voltage wires to the spark plugs, paying attention to the wiring and fixing of wire clamps, as shown in the figure.
Check spark plugs Standard
1. Disconnect the high-pro-water from spark plugs.
2. Remove the spark plugs, using a candle used key on the 16 mm.
3. Clean the spark plugs on the sand ¬ jet device or a wire brush.
4. Check the status of visual light ¬ whose plugs for wear elec ¬ trodov, damage, or thread (s) insulator. If necessary, replace ¬ those spark plug.
Table. Recommended spark ignition ¬ Gahnia.

Комментариев нет:

Отправить комментарий